Results 1 to 4 of 4

Thread: Dual Exhaust Crossmember

  1. #1
    Junior Member
    Join Date
    May 2008
    Location
    Oshawa, ON
    Posts
    11
    Rep Power
    11

    Default Dual Exhaust Crossmember

    Is anyone using one? I know there are a few out there, just wondered if anyone had any opinions. Was thinking of getting the lightweight 8lb one from Iceman (vendor on this site):

    http://www.maliburacing.com/iceman/N...ossmember.html

  2. #2
    Junior Member
    Join Date
    Dec 2008
    Location
    st-jean baptiste
    Posts
    12
    Rep Power
    10

    Default

    made myself one with 1 x 3 x 3/16 + 3/8 x 3" flat bar
    total cost 26.00

    need a mig welder
    Dan
    protouring cutlass 84:LT1+700R4 + 3:73 4 linked 9" ford diff ,dropped 2" ,4 wheel disc brakes....:power,handling,reliability ...

  3. #3

    Default

    I have two old version Icemembers. They fit great. Someday I might grab a lightweight version someday.

  4. #4

    Default

    I had a nice one made with a box cut into the pass side.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •