Announcement

Collapse
No announcement yet.

Dual Exhaust Crossmember

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Dual Exhaust Crossmember

    Is anyone using one? I know there are a few out there, just wondered if anyone had any opinions. Was thinking of getting the lightweight 8lb one from Iceman (vendor on this site):


  • #2
    made myself one with 1 x 3 x 3/16 + 3/8 x 3" flat bar
    total cost 26.00

    need a mig welder
    Dan
    protouring cutlass 84:LT1+700R4 + 3:73 4 linked 9" ford diff ,dropped 2" ,4 wheel disc brakes....:power,handling,reliability ...

    Comment


    • #3
      I have two old version Icemembers. They fit great. Someday I might grab a lightweight version someday.

      Comment


      • #4
        I had a nice one made with a box cut into the pass side.

        Comment

        Working...
        X