If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
When I started the build on my 500 Cadillac swap I knew I would need a bit more rear end than the stock 7.5”. I was looking at the available options (8.5, 12 bolt, and 9”).
As far as the 9” go there were only 3 real candidates available that were the right width, the 57-9 Ford station wagon...
This is some sites I have found from different angles and diff set ups.I hope this helps someone.I have been doing some home work and this is what I have found in my research so far upon doing the cross over from the 7.5 and the 8.8.here they are...
Leave a comment: